Pulling force mechanism and its influence on injection pultrusion

Shoujie Li*, Zhongman Ding, Ming Li, L. James Lee, Herbert Engelen, Mac Puckett


研究成果: Conference article同行評審

1 引文 斯高帕斯(Scopus)


An experimental method was developed to measure the local pulling force in several conventional pultrusion and resin injection pultrusion dies. It was found that the early part of the die contributes most to the pulling force, while the pulling resistance becomes very small after the resin has solidified. The pulling force distribution in the injection die can be modeled mathematically and the effective friction coefficient between the die surface and the moving composite can be measured by two simple devices. The influence of die design and pulling force on the quality of the pultruded composite will be discussed.

頁(從 - 到)II/-
期刊International SAMPE Symposium and Exhibition (Proceedings)
出版狀態Published - 5月 2000
事件45th International SAMPE Symposium and Exhibition - Long Beach, CA, USA
持續時間: 21 5月 200025 5月 2000


深入研究「Pulling force mechanism and its influence on injection pultrusion」主題。共同形成了獨特的指紋。