An approximate method for solving rarefied and transitional flows using TDEFM with isotropic mesh adaptation

M. R. Smith, H. M. Cave, Jong-Shinn Wu, M. N. Macrossan

研究成果: Conference article同行評審

1 引文 斯高帕斯(Scopus)

摘要

DSMC [1] can become increasingly expensive when extended to the near-continuum regime. Because of the statistical nature of the results, long run times are required to build up samples of simulator particles large enough to reduce the statistical scatter to acceptable levels. Here we adapt a kinetic theory based flux method to produce a quick approximate solver for transition and near-continuum flows. The results have no statistical scatter. The CPU times are similar to those of traditional continuum (Navier-Stokes or Euler) solvers. The True Direction Equilibrium Flux Method (TDEFM) [2, 3] is a generalisation of Pullin's kinetic theory based EFM [4]. TDEFM can transfer fluxes of mass, momentum and energy in physically realistic directions from any source cell to any destination cell, even if the cells do not share an interface. TDEFM, as an Euler solver, has been shown to provide good results on a Cartesian grid for flows where standard continuum methods produce unphysical asymmetries apparently because the continuum fluxes are constrained (in one time step) to flow in the grid coordinate directions rather than the correct physical direction. [2, 3] The new method for rarefied flow does not try to produce the correct velocity distribution function, but does ensure that mass, momentum and energy are transported within the flow over the physically correct distances between "pseudo-collisions". To ensure this, (1) the time step is restricted so that mass, momentum and energy are exchanged between contiguous cells only in one time step, and (2) the cells sizes are adapted, as steady state is approached, to be approximately equal to the local mean free path. The results for Mach 5 flow over a flat plate for varying Knudsen numbers show an average difference (compared to DSMC) in the X-velocity profile near the surface of the plate of less than 6 percent. TDEFM, employing adaptive mesh refinement, required less than 9 percent of the computational time required by DSMC for the same flow. Thus the approximate method could be useful for quick "first-estimate" solutions of otherwise time consuming design problems.

原文American English
頁(從 - 到)371-376
頁數6
期刊AIP Conference Proceedings
1084
DOIs
出版狀態Published - 13 4月 2009
事件26th International Symposium on Rarefied Gas Dynamics, RGD26 - Kyoto, Japan
持續時間: 20 7月 200825 7月 2008

指紋

深入研究「An approximate method for solving rarefied and transitional flows using TDEFM with isotropic mesh adaptation」主題。共同形成了獨特的指紋。

引用此